臺州艾菲力塑膠有限公司

• 供貨總量 : 不限
• 價格說明 : 議定
• 包裝說明 : 不限
• 物流說明 : 貨運及物流
• 交貨說明 : 按訂單

鋁塑管的連接，需要使用卡套式管件，時間久了，卡套管件，受其本身材質與工作方式的影響，連接不夠緊密，容易出現漏水的情況。PPR管材之間一般采用熱熔焊接，當需要與其它材質的管道連接時（如鋼制水管、銅制水管、熱水器等），家裝ppr水管，采用具有內、外絲口的銅制PPR管件連接。PPR管材與管材、管材與管件之間均采用熱熔焊接，徐匯區ppr水管，焊接接口位置強度與管材一致，密封性優良。

ppr管若裝在地下車庫

地下車庫的電氣預埋前結合風管、管道圖紙，避免燈具與風管和管道重疊，造成后期燈具安裝時敷設明線，增加造價及影響美觀。

車庫車庫內有橋架，但過梁較大。局部橋架過梁時可采取梁中預埋鋼制套管（套管的直徑不宜過大），這樣避免橋架從梁下上翻，影響車庫的凈高。

If PPR pipe is installed in underground garage

Before the electrical pre burying of underground garage， the air duct and pipeline drawings shall be combined to avoid the overlapping of lamps with air duct and pipeline， resulting in the laying of open lines during the later installation of lamps， increasing the cost and affecting the appearance.

There is a bridge in the garage，ppr水管規格， but the lintel is large. The steel casing (the diameter of the casing should not be too large) can be embedded in the beam when the local bridge is over the beam， so as to prevent the bridge from turning up from under the beam and affecting the net height of the garage.

水電不同槽

水路和電路不要同槽，熱水管ppr，如果發生漏水，或者產生冷凝水時，容易浸泡到電線，這是非常危險的，好相距10cm以上。如果有水電交叉的時候，水下電上。

Different hydropower tanks

Water circuit and circuit should not be the same as the groove. If water leakage or condensate water is produced， it is easy to soak into the wire. This's very dangerous， and it is better to be more than 10cm apart. If there is a water and electricity crossing， the underwater power is on.